![background image](http://html1.mh-extra.com/html/fendt/favorit-900/favorit-900_workshop-manual_4001870355.webp)
Fav 900
Transmission / Vario transmission unit
Fitting continuously variable transmission
G
Repair
Fav 900 chassis number 23/3001 and up
16.05.2001
1080
000007
G
a
3/9
Capitel
Docu-No.
Index
Date
Version
Page
Fitting continuously variable transmission
PM-Picturemodule
PM-Picturemodule
PM-Picturemodule
PM-Picturemodule
PMTAB_Picture
Tighten all four clamping screws to 86 Nm.
Screw in two drain plugs with new seals at bottom
of transmission housing and tighten.
Then operate range control I - II (check at selector
finger).
PMTAB_Picture
Turn ML transmission until tooth of one tooth of
toothed washer is in centre of bore (arrowed) for
Hall-effect sensor.
PMTAB_Picture
Coat seal surface of Hall-effect sensor with
sealant X 903.050.553 (non-curing) and insert
into bore of transmission housing. Tighten
fastening screws to 25 Nm.
Connect electric cable.
Note:
If already installed Hall-effect sensors are
re-used, stick two cardboard strips, each
0.9 mm thick, into slit in Hall-effect sensor on
left and right (for centring when fitting).
PMTAB_Picture
Pivot hydraulic motors outwards as far as stop
(45
°
).