![background image](http://html1.mh-extra.com/html/fendt/favorit-900/favorit-900_workshop-manual_4001870251.webp)
Fav 900
Transmission / Axle drives
Disassembly and reassembly of axle drives
G
Repair
17.09.2001
1015
000003
G
a
7/9
Capitel
Docu-No.
Index
Date
Version
Page
Disassembly and reassembly of axle drives
PM-Picturemodule
PM-Picturemodule
PM-Picturemodule
PM-Picturemodule
PMTAB_Picture
Locate two adjusting washers, order no.
X 534.739.501 (each 1.0 mm thick), on rear-axle
shaft (31). Then fit planet carrier and tighten.
Rotational resistance of rear-axle shaft bearing
must rise.
Note:
If rotational resistance does not rise, remove
planet carrier again and fit further adjusting
washers (26) under split ring (25) - see photo
EKI02301, then pretension rear-axle shaft
bearing again.
PMTAB_Picture
Strike bearing in both directions to relieve stress
on it.
Remove planet carrier again.
Select thickness of adjusting washers (26) such
that split ring (25) can be inserted with gentle
hammer blows.
Fit dowel pin (12) into rear-axle shaft (31).
PMTAB_Picture
Coat thread of hexagon screw (10) with synthetic
bonding agent X 903.050.084 and tighten to
350 Nm.
Strike bearing in both directions to relieve stress
on it.
PMTAB_Picture
Measure rotational resistance of shaft seal plus
bearing using torque gauge X 899.980.150 and
record result.
Target value: 4.0-6.0 Nm (bearing) plus rotational
resistance (shaft seal in photo EKI02300
e.g. 5.0 Nm).
In event of discrepancies correct by means of
adjusting washers (26) - see photos EKI02301
and EKI02303.