![background image](http://html1.mh-extra.com/html/fendt/favorit-900/favorit-900_workshop-manual_4001870334.webp)
Fav 900
Transmission / Brake system
Installation and removal of rear-wheel brake
G
Repair
09.10.2001
1070
000006
G
a
4/4
Capitel
Docu-No.
Index
Date
Version
Page
Installation and removal of rear-wheel brake
PM-Picturemodule
PM-Picturemodule
PM-Picturemodule
PM-Picturemodule
PMTAB_Picture
Insert brake pad (20) with large bore (arrowed)
pointing downwards.
Then slide intermediate disc (21) offset - see
photos EKI02321 and EKI02322 - onto pins (7).
PMTAB_Picture
Coat new shaft seals (12) on outside with
spirit/water mixture (ratio 1:1) and press centrally
into brake plate (9). Sealing lips point to
respective oil chamber.
Insert new O-ring (8) into groove in brake plate (9)
and grease. Oil ducts (arrowed) in brake plate (9)
point downwards when fitted.
PMTAB_Picture
Fit pre-assembled brake plate (9). Check position
of oil ducts - see photo EKI02323.
Tighten hexagon screws crosswise in stages to
120 Nm.
PMTAB_Picture
Fill sealing lips of shaft seals (12) 2/3 with grease.
Fully insert shaft (10).
Metallic stop must be audible when shaft is
inserted.
If metallic stop is not audible, it is possible that last
brake pad was not fitted.
Chapter 1015 Reg. G - Installation and removal
of axle drives
Chapter 1070 Reg. G - Installation and removal
of brake cylinders