![background image](http://html1.mh-extra.com/html/fendt/favorit-900/favorit-900_workshop-manual_4001870256.webp)
Fav 900
Transmission / Handbrake
Adjusting handbrake
F
Setting and Calibration
30.10.2001
1030
000001
F
a
3/3
Capitel
Docu-No.
Index
Date
Version
Page
Adjusting handbrake
PM-Picturemodule
PM-Picturemodule
PM-Picturemodule
PM-Picturemodule
PMTAB_Picture
Carry out test drive and operate handbrake.
Note:
If rear-wheel braking effect is greater on one
side: lengthen actuating linkage on side where
greater braking effect occurs.
PMTAB_Picture
Mechanically releasing (unlocking) handbrake
If air compressor is unpressurised, handbrake can
be mechanically released.
Tighten screw (22) at left rear on rear power lift as
far as stop, then tighten a further 3 to 5 turns .
Accumulator effect is cancelled out, handbrake is
free.
PMTAB_Picture
Following must be borne in mind if screw (22) is
replaced:
Slide hose (21) onto screw (22).
Grease thread of screw (22) and screw into
welded hexagon.
PMTAB_Picture
On opposite side, screw hexagon nut (20) on with
crowned face pointing downwards until screw (22)
protrudes 3.0 mm .