![background image](http://html1.mh-extra.com/html/fendt/favorit-900/favorit-900_workshop-manual_4001870459.webp)
Fav 900
Transmission / Live PTO
Installation and removal of live PTO gearbox
G
Repair
28.08.2001
1220
000003
G
a
14/17
Capitel
Docu-No.
Index
Date
Version
Page
Installation and removal of live PTO gearbox
PM-Picturemodule
PM-Picturemodule
PM-Picturemodule
PM-Picturemodule
PMTAB_Picture
Align externally toothed discs (12) and press
clutch bell housing (3) in place as far as stop.
PMTAB_Picture
Locate existing adjusting washer (1) or adjusting
washers (1) on deep-groove ball bearing (2).
Measure and record distance to flange surface.
E.g. 178.6 mm
PMTAB_Picture
Distance from bearing face surface to flange
surface is marked in white at top in rear-axle
housing.
E.g. 178.71 mm
Distance from adjusting washer of deep-groove
ball bearing (2) to flange surface of housing cover
must be 0.1-0.2 mm less than marked distance.
In other words, bearing system must have
play of 0.1-0.2 mm.
In event of discrepancies, correct using adjusting
washer (1).
PMTAB_Picture
Distance of lower shaft from bearing face surface
to flange surface is marked in white at bottom in
rear-axle housing.
E.g. 148.75
Note:
This dimension is not required for repairs
since a measurement device is needed to
measure bearing play.
To check bearing play in lower shaft (120): see
description below.