Fav 900
Engine / Short block
Removing and refitting air compressor
G
Repair
Fav 900 Chassis number 23/3001 and up
23.2.2001
2210
000013
G
a
3/5
Capitel
Docu-No.
Index
Date
Version
Page
Removing and refitting air compressor
PM-Picturemodule
PM-Picturemodule
PM-Picturemodule
PM-Picturemodule
PMTAB_Picture
Place compressor drive gear (1) onto compressor
crankshaft using mounting plate (2) (Special
Tool).
Note:
Drive gear must be mounted free of grease or
oil.
Tighten drive gear nut (3) at 200-250 Nm (148 -
184 lb-ft.).
PMTAB_Picture
Remove screws (2) of mounting plate (1) out of
drive gear.
Remove mounting plate.
Screw and tighten connection fittings for coolant
and compressed air using new gaskets into the
cylinder.
PMTAB_Picture
Refitting the compressor
Thoroughly clean sealing faces in compressor
control timing case cover.
Use new gaskets and Oil O-rings with silicon oil.
O-Rings on eccentric flange must be replaced and
greased with silicon oil.
Position flywheel into "TDP" position.
Place lever from the compressor excenter flange
onto the highest position.
PMTAB_Picture
Position compressor crankshaft in such a manner
that "TDP" mark on top and the upper edge of the
drive fork (1) in positon (2) remains about 15
°
before the unmachined lowlaying part (3) .
Place compressor into timing case using a new
O-Ring .
