![background image](http://html1.mh-extra.com/html/fendt/favorit-900/favorit-900_workshop-manual_4001870176.webp)
Farmer 400
Fav 700
Fav 900
Tractor / General system
General points on calibration
F
Setting and Calibration
10/2000
0000
000012
F
a
1/1
Capitel
Docu-No.
Index
Date
Version
Page
General points on calibration
Text-module
In order to equalise the mechanical and electrical tolerances of the sensors, it is necessary to calibrate
the relevant sensor. If a sensor is replaced, the replacement must be calibrated. A complete calibration
must generally be carried out after replacement of the e-boxes (A001, A002), EPC (A005),
control console (A004) or actuator unit (A009).
Text-module
ETNum-list
Text-module
Note:
Keep to the calibration sequence.
Calibrations 1. - 6. can be carried out as required.
Calibrations 7. - 11 (13 - Fav 900 from 23/3001 onwards) must be carried out in ascending order
and in a block (transmission calibration).
Calibrations 12. - 13. can be carried out as required (engine EDC)
The emergency control must not be engaged during calibration.
Text-module
If incorrect values are found or conditions are not met, ERROR message is displayed.
If calibration proceeds without errors, OK is displayed, and new sensor settings are stored.
Data are only accepted when ignition key is turned to position "0".
The following sensors and functions have to be calibrated.
1. Calibration - rear EPC, code 8001 and 8002
2. Calibration - enhanced-control front power lift (where fitted), code 9001 and 9002
3. Calibration - hydraulic auxiliary control valves ( not Farmer 400), code 1001
4. Calibration - suspension sensor, code 7666
5. Calibration - engagement point of rear PTO, code 6034
6. Calibration - engagement point of front PTO, code 7034
7. Calibration - clutch pedal sensor, code 4001
8. Calibration - range control sensor, code 4003
9. Calibration - accelerator sensor, code 4005
10. Calibration - transmission ratio characteristic curve, code 4007
11. Calibration - turboclutch operation, code 4009
12. Calibration - hand throttle (only Fav 900/23/... EDC), code 4002
13. Calibration - accelerator (only Fav 900/23/... EDC), code 4005