Farmer 400
Fav 700
Fav 900
Transmission / brake system
Setting magnet for solenoid switch (S005 / S006)
E
Testing
8.2.2001
1070
000002
E
a
1/2
Capitel
Docu-No.
Index
Date
Version
Page
Setting magnet for solenoid switch (S005 / S006)
PM-Picturemodule
Text-module
1. Release brake pedals. Setting is carried out individually.
2. Place 3 mm thick spacer (DIY) between snubber of stop screw A and brake pedal E
(corresponding to pedal travel of approx. 16 mm).
3. Connect test lamp to pin 1 (brown) and pin 2 (white), (brake light / trailer advance-braking control
system) of solenoid switch S005 .
Note:
Elec. circuit diagram for brake light, compressed-air advance control system -
Chapter 9000 Index C page 9
4. Slide magnet D towards switch S005 until test lamp lights up.
5. Tighten magnet D .
6. Remove 3 mm spacer from between snubber of stop screw A and brake pedal E .
Text-module
Checking setting
- Set ohmmeter to 2 KOhm range and connect to pin 3 (white) and pin 4 (brown/yellow) (diff. lock /
control console A004) of switch S005 .
Note:
Elec. circuit diagram for 4WD and diff. locks - Chapter 9000 Index C page 30
Brake pedal E released and not operated
- Pilot bulb of test lamp must light up.
- Ohmmeter must indicate approx. 120 ohms .
PM-Picturemodule
Text-module
Magnet for solenoid switch S006 is set in same fashion
PMTAB_Picture
Setting magnet for solenoid switch S005 S006
At top of steering column.
Remove combi-instrument A007.
Loosen feed reservoir for brake and clutch
hydraulic system and swivel to one side.
PMTAB_Picture
Release and operate brake pedal E.
- Pilot bulb of test lamp must go out after brake
pedal travel of 25 mm.
- Ohmmeter must indicate approx. 500 ohms
after 25 mm at latest.
