SEW-Eurodrive MOVIDRIVE compact MCH41A, System Manual

Page: 392 / 436

392
System Manual – MOVIDRIVE® compact Drive Inverters
11
Operating displays for MC_40A (without fieldbus)
Operation
11 Operation
11.1 Operating displays for MC_40A (without fieldbus)
The operating status of MOVIDRIVE
®
compact
MC_40A are displayed on LED V1.
[1] Operation LED V1 (three colors: green/red/yellow)
Operation LED V1 The operating status of MOVIDRIVE
®
compact MC_40A is displayed by the three-color
LED V1 (green/red/yellow).
05428BXX
Figure 160: MOVIDRIVE
®
compact MC_40A operating display
[1]
Color Operating state Description
- OFF Without voltage
No supply voltage and no DC 24 V
backup voltage.
Yellow Steady light
Controller inhibit or
No enable
Unit ready but controller inhibit active
(DIØØ = "0") or no enable.
Green Steady light Enable Motor is energized.
Red Steady light Locking system error Error causes unit to disconnect.
Yellow Flashing Unit not ready
Factory setting in progress or DC 24 V
backup mode without supply voltage.
Green Flashing Flying start in process
Operating mode VFC & FLYING
START is set and inverter connected
to a rotating motor.
Green/red
Flashing
0.5 s green / 0.5 s red
Limit switch contacted
Limit switch reached in "enable"
operating status.
Yellow/red
Flashing
0.5 s yellow / 0.5 s red
Limit switch contacted
Limit switch reached in "Controller
inhibit" operating status.
Green/red
Flashing
green green red red Display or wait system
error
Fault in "enable" operating status.
Fault is only displayed and does not
lead to a switch-off.
Yellow/red
Flashing
yellow yellow red red Display or wait system
error
Fault in "controller inhibit" operating
status. Fault is only displayed and
does not lead to a switch-off.
Green/yellow
0.75 s green /
0.75 s yellow
Timeout active
Enable ineffective, inverter is waiting
for a valid telegram.