SEW-Eurodrive MOVIDRIVE compact MCH41A, System Manual

Page: 342 / 436

342
System Manual – MOVIDRIVE® compact Drive Inverters
10
Complete parameter list
Startup
10.6 Complete parameter list
General
information
• The parameters of the quick menu are marked by a "/" (= display on the DBG11B
keypad).
• The factory setting for the parameter is highlighted in bold.
Par. Name Value range Par. Name Value range
DISPLAY VALUES 07_ Unit data
00_ Process values 070 Unit type
000 Speed –5000...0...5000 1/min 071 Rated unit current
001/ User display [Text] 076 Firmware basic unit
002 Frequency 0... 1100 Hz 077 Technology function
003 Actual position –2
31
–1...0...2
31
–1 inc 08_ Error memory
004 Output current 0...200 % I
N
080/ Error t-0
005 Active current –200...0...200 % I
N
081 Error t-1
006/ Motor utilization 1 0...200 % 082 Error t-2
007 Motor utilization 2 0...200 % 083 Error t-3
008 DC link voltage 0...1000 V 09_ Bus diagnostics
009 Output current A 090 PD configuration
01_ Status displays 091 Fieldbus type
010 Inverter status 092 Fieldbus baud rate
011 Operating state 093 Fieldbus address
012 Error status 094 PO1 Setpoint
013 Current parameter set 1/2 095 PO2 Setpoint
014 Heat sink temperature –20...0...100 °C 096 PO3 Setpoint
015 Hours of operation 0...25000 h 097 PI1 Actual value
016 Enable hours 0...25000 h 098 PI2 Actual value
017 Work kWh 099 PI3 Actual value
02_ Analog setpoints
020 Analog input AI1 –10...0...10 V
021 Analog input AI2 –10...0...10 V
022 External current limit 0...100 %
03_ Binary inputs basic unit
030 Binary input DIØØ /CONTROL.INHIBIT
031 Binary input DIØ1
032 Binary input DIØ2
033 Binary input DIØ3
034 Binary input DIØ4
035 Binary input DIØ5
036/ Status of binary inputs on basic unit
05_ Binary outputs basic unit
050 Binary output DBØØ /BRAKE
051 Binary output DOØ1
052 Binary output DOØ2
053/ Status of binary outputs on basic unit
0 0
I