264
System Manual – MOVIDRIVE® compact Drive Inverters
7
Transportation, putting into storage
Safety Notes
7.4
Transportation, putting into storage
Observe the notes on transportation, storage and proper handling. Observe the climatic
conditions as stated in the section "General technical data."
7.5
Installation
Installation and cooling of the devices must take place according to the guidelines listed
in the corresponding documentation.
Protect the drive inverters from excessive strain. Especially during transportation and
handling, do not allow the components to be deformed or insulation spaces altered.
Avoid contact with electronic components and contacts.
Drive inverters contain components that can be damaged by electrostatic energy and
improper handling. Prevent mechanical damage or destruction of electric components
(may pose health risk!)
The following applications are prohibited unless measures are expressly taken to make
them possible:
•
Use in potentially explosive atmospheres
•
Use in areas exposed to harmful oils, acids, gases, vapors, dust, radiation, etc.
•
Use in non-stationary applications that are subject to mechanical vibration and shock
loads in excess of the requirements in EN50178
7.6
Electrical connection
Observe the applicable national accident prevention guidelines when working on live
drive inverters (e.g. BGV A3).
Perform electrical installation according to the pertinent regulations (e.g. line cross
sections, fusing, protective conductor connection). For any additional information, refer
to the applicable documentation.
You will find notes on EMC-compliant installation, such as shielding, grounding,
arrangement of filters and routing of lines, in the documentation of the drive inverters.
Always observe these notes even with drive inverters bearing the CE marking. The
manufacturer of the system or machine is responsible for maintaining the limits
established by the EMC legislation.
Preventive measures and protection devices must correspond to the regulations in force
(e.g. EN 60204 or EN 61800-5-1).
Required preventive measures: Ground the unit.
7.7
Safe disconnection
The unit meets all requirements for safe disconnection of power and electronic
connections in accordance with EN 61800-5-1. All connected circuits must also satisfy
the requirements for safe disconnection.
Summary of Contents for MOVIDRIVE compact MCH41A
Page 2: ...SEW EURODRIVE Driving the world...
Page 432: ......
