![background image](http://html1.mh-extra.com/html/omron/r88d-kn-series/r88d-kn-series_user-manual_742799412.webp)
Appendicies
A-12
G5 Series AC Servo Drives With Built-in EtherCAT Communications, Linear Motor Type
(c) Example of Servo OFF during Operation in cst
*1
When the servo is turned OFF, a deceleration stop starts and 6061 hex continues to show the same mode as
the mode of operation (cst) specified in 6060 hex.
*2
After the motor stops, No mode assigned is shown by 6061 hex.
*3
Bit 12 will be
“
0
”
during a deceleration due to servo OFF.
*4
The mode shown in 6061 hex is forced to
“
0
”
because the mode shown in 6061 hex is different from the mode
of operation.
Note
The operation during the interval from A to B for drive prohibition and main circuit power OFF is the same as
when the servo is turned OFF.
6061 hex
30 mm/s
cst
Operation enabled
Switched on
No mode assigned
0
0
6060 hex
cst
(VCMP)
(NEAR)
1
0
1
0
(Target position ignored)
1
0
0
1
0
*3
*1
0
(VLIM)
(DEN)
(Following error)
(Target reached)
A
*2
B
(Remote)
0
0
*4
0
*4
0
*4
0
*4
0/1
6041 hex: Bit 10
6041 hex: Bit 12
6041 hex: Bit 13
4000 hex: Bit 1
4000 hex: Bit 4
4000 hex: Bit 7
4000 hex: Bit 8
Actual speed
Servo ON
Servo OFF
PDS state
6041 hex: Bit 9