![background image](http://html1.mh-extra.com/html/omron/r88d-kn-series/r88d-kn-series_user-manual_742799518.webp)
Appendicies
A-11
8
G5 Series AC Servo Drives With Built-in EtherCAT Communications, Linear Motor Type
Event name
Phase-A Connection Error
Event code
08140000 hex
Meaning
An error such as broken wiring was detected in the external encoder phase-A connection.
Source
EtherCAT Master Function Module
Source details
Slave
Detection
timing
Continuously
Error attributes
Level
Minor fault
Recovery
Error reset (after
cycling slave
power)
Log category
System
Effects
User program
Continues.
Operation
Power drive circuit is OFF for relevant slave.
Indicators
EtherNet/IP NET RUN
EtherNet/IP NET ERR
EtherNet/IP LINK/ACT
---
---
---
System-defined
variables
Variable
Data type
Name
None
---
---
Cause and
correction
Assumed cause
Remedy
Prevention
An error such as broken wiring was
detected in the external encoder
phase-A connection.
Wire phase A of the external encoder
correctly as shown in the wiring
diagram. If the cable is broken,
replace it.
Wire phase A of the external encoder
correctly as shown in the wiring
diagram.
Attached
information
None
Precautions/
Remarks
“
55
”
is displayed on the Servo Drive front panel and F055 is given as the AlarmCode (4001 hex).
Event name
Phase-B Connection Error
Event code
08150000 hex
Meaning
An error such as broken wiring was detected in the external encoder phase-B connection.
Source
EtherCAT Master Function Module
Source details
Slave
Detection
timing
Continuously
Error attributes
Level
Minor fault
Recovery
Error reset (after
cycling slave
power)
Log category
System
Effects
User program
Continues.
Operation
Power drive circuit is OFF for relevant slave.
Indicators
EtherNet/IP NET RUN
EtherNet/IP NET ERR
EtherNet/IP LINK/ACT
---
---
---
System-defined
variables
Variable
Data type
Name
None
---
---
Cause and
correction
Assumed cause
Remedy
Prevention
An error such as broken wiring was
detected in the external encoder
phase-B connection.
Wire phase B of the external encoder
correctly as shown in the wiring
diagram. If the cable is broken,
replace it.
Wire phase B of the external encoder
correctly as shown in the wiring
diagram.
Attached
information
None
Precautions/
Remarks
“
55
”
is displayed on the Servo Drive front panel and F155 is given as the AlarmCode (4001 hex).