Lucent Technologies WaveStar OLS 40G, Installation Manual

Page: 568 / 578

G-10
Issue 1.0 March 2001
365-575-389
Installation Manual
Related Equipment
Dantel Options Setting (Continued)
Description
(continued) Table G-2. Dantel Orderwire Options Settings for Voice and Data
Communications (continued)
Module Settings
44202 202 Set the TEST, ALB, and DLB switches in the DOWN
positions on faceplate.
Set the 2W/4W switch to 4W.
set the S5 dip switch as follows:
S5-1, S5-3, and S5-4 ON.
S5-2 and S5-5 OFF.
Set the RCV GAIN strap to HIGH.
Set the XMT GAIN strap to LOW.
Set XMT and RCV straps to MASTER.
Set 485TD, 422RTS, and 422TD straps to O (OUT).
Reinstall the module in the middle slot in the top
equipment shelf.
44020 49018 child board, set the station 1 code with S1, S2
and S3 = unique three-digit voice orderwire address
(000-999) for each site. S1 is the first digit. It is
recommended to use the Target ID (TID).
49018 child board S4, S5 and S6 = unique three-digit
(and other) modem address (000-999) for each site.
This address must be unique from all the primary voice
Orderwire addresses assigned in the ring.
Reinstall the module in the left slot in the bottom
equipment shelf.
44022 Set the 2W/4W switch to 4W.
Set the 0 OHM/600 OHM to 600 OHMs.
Set the Remote Lead to OUT.
Reinstall the module in the middle slot in the bottom
equipment shelf.
49920 Set RING-BACK TONE STRAPS to ON.
Set INTERRUPT STRAPS to NORM.
Set S2 switch to ON.
Reinstall the module in the right slot in the bottom
equipment shelf.