Lucent Technologies WaveStar OLS 40G, Installation Manual

Page: 172 / 578

5-16
Issue 1.0 March 2001
365-575-389
Installation Manual
Wired Cable Installation
Serial, Parallel, and X.25 Telemetry
Cable Installation (Continued)
OLS Serial
Telemetry Cables
Installation
(continued) WaveStar OLS 40G Serial Telemetry Cable Installation Procedure
Perform the following steps to install serial telemetry cables:
X.25 (TL-1)
Telemetry Cable
Installation
X.25 is a synchronous network communication protocol commonly used with
operations systems. It utilizes transaction language 1 (TL1) for the message
language. The X.25 (TL-1) connection is supported only for OLS. The OT X.25
connection is not supported for any Release of OT or OLS.
Available OLS X.25 Telemetry Cables
Table 5-7 lists cables available for OLS X.25 applications.
Table 5-7. OLS X.25 Telemetry Cable
(Continued on next page)
Step Action
1 Route the serial telemetry cables out of the right side of the OLS shelf to
the serial telemetry system.
Refer to Figure 5-1 on page 5-4 for location on the Interconnection panel.
2 Connect serial telemetry cable 1 to P19 on the interconnection panel.
3 Connect the serial telemetry cable to the serial telemetry system by
cutting the cable to length and wire-wrapping the loose ends onto the
panel.
4 Label the connections that are wire-wrapped.
5 Dress and tie the cables.
ED-7G028-22
Cable Group
Cable Length (ft.)
Connector Types
F = Female
M = Male
602 As Required (150’ max.) F-M
652 150’ F-M