Lucent Technologies WaveStar OLS 40G, Installation Manual

Page: 509 / 578

Issue 1.0 March 2001
B-7
365-575-389
Installation Manual Pin Repair
Procedures for Pin Replacement
Description
!
CAUTION:
This procedure must been done with the shelf out of service and powered
down to insure no further damage to the equipment or to the person doing
the pin replacement.
Step Action
1 Determine if the bent or broken pin is in an WaveStar OLS 40G OT.
2 Determine the shelf in which the bent or broken pin resides (ex. OLS).
3 Determine the circuit pack slot in which the pin resides.
4 Determine the number and column location of the pin.
5 Refer to the correct figure (Figure B-1 through Figure B-8) to determine
the letter pin code associated with the pin.
6 Using Table B-1 on page B-4, determine the type of pin (either METRAL
or FASTECH) and the correct comcode for the replacement pin.
7 Obtain the correct replacement pin (See the Applications, Planning, and
Ordering Guide for ordering information).
8 If the pin to be replaced is a METRAL type pin, refer to “METRAL Press-
Fit Repair Kit MT370-01” documentation for proper procedures to remove
and replace the bent or broken pin.
9 If the pin to be replaced is a FASTECH type pin, refer to “KS-22876, L513
Instruction Pin replacement for FASTECH Technology Using the KS-
22876 L6 Pin Kit” documentation for proper procedures to remove and
replace the bent or broken pin