Lucent Technologies WaveStar OLS 40G, Installation Manual

Page: 463 / 578

Issue 1.0 March 2001
10-27
365-575-389
Installation Manual Fiber Connections
Repeater B Direction Connection
(Continued)
Line 1 Connection
Procedures
(continued)
Step Action Reference
3 Clean and then connect the other end of the jumper
above to its assigned LGX location.
4 Select an OA IN LBO based on the measured power and
the number of OC-48 wavelengths (channels) present. See LBO
Selection
Procedures.
5 Install the appropriate LBO in 1B OA IN connector if
necessary.
6 Connect the jumper to the 1B OA IN connector.
Requirement: The 1B OA FAULT LED shall stop
flashing within 1 minute.
7 Clean and then connect 1B OA OUT to an optical power
meter. Use Test point 2P. Figure 10-6
on page
10-29
8 Verify the OA Output Power by referring to the table. Table 10-4 on
page 10-11
9 For 7-8 span applications, install a 3 dB LBO in the OA
1B OUT. Clean and then connect the jumper from OA 1B
OUT to the LGX. Use Test point 2P. Figure 10-6
on page
10-29