Lucent Technologies WaveStar OLS 40G, Installation Manual

Page: 537 / 578

Issue 1.0 March 2001
D-7
365-575-389
Installation Manual
CMC Dantel Alarm and Control Block Installation,
Extended Miscellaneous Discretes
Installation Procedure (Continued)
Wiring (continued) Figure D-4. Power Supply Board Component Location
(Continued on next page)
RS - 232 OR 202
SUBASSEMBLY
1 3
AUX LED
S1
S2 S3
F1
TB1
P1
- 4
8
AL
M
GN
D
Step Action
4 Wire the alarm inputs (refer to Figure D-5 on page D-8). There are two
pins for each alarm input. One is for ground and the other is for alarm
input. The dark-colored columns are grounds and are wired together.
Wire Pin 30 S back to the Battery return ground terminal (GND) on TB-1
(refer to Figure D-4 on page D-7). Pin 1 will begin with Input Point 17
(See Figure D-5 on page D-8). Table D-2 on page D-8 lists the SER
TLM1 cable connections and designations and the Dantel Pin
designations.
5 The TBOS Transmit and Receive Positive and Negative (see Table D-2
on page D-8) need to be wire-wrapped to pins 32 E-H on the Alarm and
Control Block (See Figure D-5 on page D-8).
CABLE 1
CABLE 2
1. TBASTXP (W) to 32-E 3. TBASRXP (W) to 32-G
2. TBASTXN (BL) to 32-F 4. TBASRXN (O) to 32-H