Lucent Technologies WaveStar OLS 40G, Installation Manual

Page: 302 / 578

6-74
Issue 1.0 March 2001
365-575-389
Installation Manual
WaveStar OLS 40G Fiber and Circuit Pack Installation
Two OA/One OA Dual Facing Shelf
Installation
Description
This configuration is supported by Releases 2.1 and subsequent releases only.
The information in this subsection contains the information to fiber a 2-line Dual
Facing shelf. It is possible that there will be two shelves in the bay being installed.
Refer to the appropriate subsection to fiber the other shelf contained within such a
bay.
This subsection covers the fiber and label installation for the Two OA/One OA
Dual Facing Shelf Configuration. It has been broken into five procedures:
■
Intrashelf Fiber Jumper Installation
■
Low-Speed Fiber Jumper Installation to SONET/SDH equipment
■
Outside Plant Fiber Jumper Installation to LGX
■
Customer Maintenance Signal Fiber Jumper Installation
■
End Terminal Circuit Pack and Unit Installation
!
CAUTION:
No fiber jumpers shall be connected to the circuit packs or units at this time.
Do not connect the fiber jumpers until instructed to do so.
Circuit Pack Equip
Procedure for
2-Line Shelf
(Continued on next page)
Step Action
1 Review information in the Fiber Cable Routing: page 6-9 and the Circuit
Pack Installation: page 6-10 sections before beginning this procedure.
2 Refer to Figure 6-15 for circuit pack locations.