Lucent Technologies WaveStar OLS 40G, Installation Manual

Page: 377 / 578

Issue 1.0 March 2001
8-11
365-575-389
Installation Manual Network Element Startup and Provisioning
Circuit Pack Insertion
General
Considerations
n
A wrist strap, connected to the wrist strap ground jack, must be worn when
handling circuit packs.
n
Circuit packs are keyed to prevent being inserted into the wrong shelf
position.
n
Before installing any circuit packs, inspect the circuit pack side of the
backplane for any bent or broken backplane pins. If any pins are found to
be bent, straighten the pin if possible.
n
Any broken pins or bent pins that cannot be straightened must be replaced
using the BERG MT370-01 pin kit for the METRAL pins. Refer to
Appendix
B, Pin Repair .
n When installing circuit packs, use care to insert them straight to avoid
damaging the circuit packs or the backplane pins.
n Fiber connectors on optical circuit packs should always be either
connected to fiber or covered by protective covers. Note that the fibers
should not be connected to the circuit packs or units at this time.
Installing the
Controller Packs Follow the steps in the table below to insert the controller packs:
Step Action Reference
1 Seat the LEA5 TOHCTL into its slot in the lower shelf
Requirement: After a 5 minute reset the FAULT LED
will extinguish.
2 Seat the LUD1 OTCTL into its slot on the OT System
shelf if an OT System will be integrated with the
WaveStar OLS 40G.
Requirement: After about a 2 minute reset the FAULT
LED will extinguish.