Lucent Technologies WaveStar OLS 40G, Installation Manual

Page: 273 / 578

Issue 1.0 March 2001
6-45
365-575-389
Installation Manual WaveStar OLS 40G Fiber and Circuit Pack Installation
Repeater Installation (Continued)
Fiber Jumper
Installation
(continued) Table 6-16. Customer Maintenance Fiber Jumpers for Repeaters
Fiber Protection If fiber duct is not installed, use the split polyethylene fiber protection tubing
supplied in the Installation Kit C848065959 to protect the fibers that run down
through the sides of the shelf. Refer to Figure 6-2 or Figure 6-8.
Fiber Dressing All fiber jumpers should dress from their circuit pack or unit connectors down
through the notches immediately below the connectors at the bottom edge of the
shelf then horizontally along the shelf trough to the appropriate side as shown in
Figure 6-7 and Figure 6-8.
NOTE:
Place the fibers through the fiber clips one at a time to avoid overstressing
the clips and possibly damaging the fibers.
Application Line
Connect
Point
Circuit
Pack Connector Label to Install
Repeater
Refer to
Figure 6-8 on
page 6-44 for
connection point
1 A TLM 1A CM IN 1A-TLM-CMIN
B TLM 1A CM OUT 1A-TLM-CMOUT
C TLM 1B CM IN 1B-TLM-CMIN
D TLM 1B CM OUT 1B-TLM-CMOUT
2 E TLM 2A CM IN 2A-TLM-CMIN
F TLM 2A CM OUT 2A-TLM-CMOUT
G TLM 2B CM IN 2B-TLM-CMIN
H TLM 2B CM OUT 2B-TLM-CMOUT