Lucent Technologies WaveStar OLS 40G, Installation Manual

Page: 451 / 578

Issue 1.0 March 2001
10-15
365-575-389
Installation Manual Fiber Connections
Repeater A Direction Connection
Procedure (Continued)
Line 1 Connection
Procedures
(continued)
Step Action Reference
2 Clean and then connect fiber assigned to 1A OA IN to an
optical power meter. Test point 1P on Figure 10-3.
3 Clean and then connect the other end of the above
jumper to its assigned LGX location.
4 Select an OA IN LBO based on the measured power and
the number of OC-48 wavelengths (channels) present. See LBO
Selection
Procedures.
5 Install the appropriate LBO in 1A OA IN connector.
6 Connect the jumper to the 1A OA IN connector.
Requirement: The 1A OA FAULT LED shall stop
flashing within 1 minute.
7 Clean and then connect 1A OA OUT to an optical power
meter. Test point 2P on Figure 10-3.
8 Verify the OA Output Power by referring to Table 10-4
on page 10-11.
9 Clean and then connect the jumper from OA 1A OUT to
the LGX Test point 2P on Figure 10-3. If the application
is for 7-8 spans, install a 3 dB LBO on OA 1A OUT port
prior to installing the fiber.