Lucent Technologies WaveStar OLS 40G, Installation Manual

Page: 446 / 578

10-10
Issue 1.0 March 2001
365-575-389
Installation Manual
Fiber Connections
DS-NE Office Transmit OA Connection
Procedure
Notes and Cautions Read carefully the following notes and cautions before beginning the procedures:
NOTE:
The following procedure assumes lines 1 and 2 are both equipped. Ignore
the procedures for unequipped lines.
!
DANGER:
Disabling the Automatic Power Shut-Down (APSD) feature results in a FDA/
IEC ClassIIIb/3B laser hazard. APSD is a safety feature. Do not attempt to
defeat or disable APSD. Defeating APSD may result in harm to personnel
exposed to disconnected or cut optical fibers.
!
CAUTION:
To comply with IEC regulations, systems containing an IEC Class 3B laser
hazard must be installed in a controlled environment. Please refer to
applicable IEC standards.
NOTE:
At any time throughout the test procedure remove attenuated test cable if
measured power is within the range of the optical power meter.
Line 1 Connection
Procedures
Follow the steps in the table below to make the connection at the DS-NE Office
Transmit:
(Continued on next page)
Step Action Reference
1 The APSD feature must be disabled in order to measure
the OA receive power and select the appropriate
attenuation for the receiving amplifier. Disable the APSD
at this time. See Danger
above.