Lucent Technologies WaveStar OLS 40G, Installation Manual

Page: 484 / 578

11-12
Issue 1.0 March 2001
365-575-389
Installation Manual
Connecting SONET/SDH Systems to WaveStar OLS
40G
Connect Optical Line System to
SONET/SDH/1-Gb Ethernet
(Continued)
Connect WaveStar
OLS 40G to
Compatible
SONET/SDH/1-Gb
Ethernet Receivers
(continued)
Step Action
4 For Releases 2.1 and subsequent releases, refer to the SmartManual
furnished by the CMC.
5 At the receiver or OTU/OTPM, connect the measured jumper to the input
connector.
Requirement: The FAULT LED shall stop flashing within 1 minute. (Loss
of Signal (LOS) alarm extinguishes.)
6 At the transmitting end of the WaveStar OLS 40G (the previous SONET/
SDH/ 1-Gb Ethernet), momentarily remove then reconnect the fiber from
the SONET/SDH/1-Gb Ethernet transmitter.
Requirement: The optical power meter shows a momentary loss of
optical power. (Power drops at least 25 dB on the meter.)
7 Proceed to the “Add Additional Wavelengths: page 11-13” section for
systems with OLS compatible receivers. Proceed to the “Connect OT/
OTPM to Generic SONET/SDH/1-Gb Ethernet Receivers: page 11-13”
section for systems without OLS compatible receivers.