Lucent Technologies WaveStar OLS 40G, Installation Manual

Page: 29 / 578

Issue 1.0 March 2001 xxix
365-575-389
Installation Manual About This Document
How to Use This Manual (Continued)
Section
Descriptions
(continued)
(Continued on next page)
Chapter Number
and Title Description
Chapter 11,
"Connecting SONET/
SDH Systems to
WaveStar OLS 40G" Describes fiber jumper installation and testing between
SONET/SDH Systems and the WaveStar OLS 40G End
Terminal equipment.
Chapter 12,
"Troubleshooting" Provides guidelines for troubleshooting an
out-of-service system during initial start-up.
Appendix A, "Releases
1.0 and 2.0 LBO
Selection Tables" Provides the information for LBO selection tables when
installing R 1.0 and R 2.0 OLS/OT.
Appendix B, "Pin
Repair" Describes how to repair backplane pins that need to be
replaced.
Appendix C, "Fiber
Cleaning" Describes how to clean the optical connectors.
Appendix D, "CMC
Dantel Alarm and
Control Block
Installation, Extended
Miscellaneous
Discretes" Describes how to install the Dantel Alarm Control Block
for use with the extended miscellaneous discretes
feature.
Appendix E, "Harris C-
1000 Centurion
Installation —
Extended
Miscellaneous
Discretes" Describes how to install the Harris C-1000 Centurion for
use with the extended miscellaneous discretes feature.
Appendix F, "PC Setup
& Usage For
CenterLink
Management Console" Describes the setup and use of the Centerlink
Management Console (CMC) software for use as the
Craft Interface Terminal (CIT) for the WaveStar OLS
40G.