Lucent Technologies WaveStar OLS 40G, Installation Manual

Page: 189 / 578

Issue 1.0 March 2001
5-33
365-575-389
Installation Manual Wired Cable Installation
OT Miscellaneous Mount Intershelf
Wiring (Continued)
Description
(continued)
Install the List 10 intershelf cables as follows:
Table 5-20. Shelf Interconnecting Cables for List 10
(Continued on next page)
Step Action
1 Install inter shelf cables as specified in Table 5-20. Refer to Figure 5-4.
2 Route cables out the left or right side access holes as specified in
Table 5-20. When all the cables have been installed, tie excess cable into
left or right bay frame channels.
3 Upon completion of Table 5-20 interconnections, verify that
ED-7G045-20, GR2 termination connectors were factory installed on
System Shelf J6 and Complementary Shelf 2 J7. If missing, install
replacement terminations. These are required for proper system
performance.
4 Using the (J69000C-1, List 161) shelf label kit, apply the identification
labels to OT Bay 1 per the following:
■
LOW to System Controller Shelf
■
MID to Complementary Shelf 1
■
UP to Complementary Shelf 2
5 If the system has an OT Bay 2, apply labels in the same location as listed
for OT Bay 1 using the (J69000C-1, List 161) shelf label kit.
Cable Part No.
Side to
Run Cable
From
Shelf/Jack
To
Shelf/Jack
Connector
Pin Size
ED-7G045-20, GR6 Left System Shelf/
P7 to J7 Compl. Shelf 1/
P6 to J6 15
ED-7G045-20, GR7 Left System Shelf/
P9 to J9 Compl. Shelf 1/
P8 to J8 15
ED-7G045-20, GR8 Left System Shelf/
P10 to J10 Compl. Shelf 2/
P8 to J8 15