Lucent Technologies WaveStar OLS 40G, Installation Manual

Page: 275 / 578

Issue 1.0 March 2001
6-47
365-575-389
Installation Manual WaveStar OLS 40G Fiber and Circuit Pack Installation
One OA 1A-TX End Terminal
Installation
Description
This configuration is support by Releases 2.1 and subsequent releases of
software only.
This configuration is most commonly used as a stand-alone shelf or coupled with
another configuration in a Dual shelf bay.
This subsection covers the fiber and label installation for the One OA 1A-TX End
Terminal configuration. It has been broken into five procedures:
■
Intrashelf Fiber Jumper Installation
■
Low-Speed Fiber Jumper Installation to SONET/SDH equipment
■
Outside Plant Fiber Jumper Installation to LGX
■
Customer Maintenance Signal Fiber Jumper Installation
■
End Terminal Circuit Pack and Unit Installation
!
CAUTION:
No fiber jumpers shall be connected to the circuit packs or units at this time.
Do not connect the fiber jumpers until instructed to do so.
Circuit Pack Equip
Procedure for 2-
Line Systems
NOTE:
A particular bay or cabinet may be equipped with two OLS shelves to be
configured as a Dual 2-Line system. Each of the two shelves can be
represented by Figure 6-9, and should be equipped and fibered individually.
(Continued on next page)
Step Action
1 Review information in the Fiber Cable Routing: page 6-9 section and the
Circuit Pack Installation: page 6-10 section before beginning this
procedure.
2 Refer to Figure 6-9 for circuit pack locations.