Lucent Technologies WaveStar OLS 40G, Installation Manual

Page: 410 / 578

9-20
Issue 1.0 March 2001
365-575-389
Installation Manual
Local Installation Testing
Auto Turnup Local Test (Continued)
Auto Turnup Local
SUPR Procedures
for End Terminals
(continued)
Step Action Reference
4 Verify the customer maintenance signal connectors (CM
IN/CM OUT) are not looped.
5 Execute CONFIGURATION.Update.System.
Requirement: The command clears loss of signal
alarms. FAULT LEDs on all OAs are off and are not
flashing.
6 Execute FAULT.Test.Auto.Local. Enter SUPR-All in the
box provided. This test will take up to 5 minutes,
depending on how many lines are equipped (typically
less than 1 minute).
Requirement: Results will be displayed on the CMC
screen. A good slot will report Good. A failed slot will
report FAIL. A “-” represents an untested slot (no circuit
pack equipped). If any slot fails, move it’s circuit pack to
a good slot and verify the test again. Replace the circuit
pack in the failed slot if indicated that the failure moves
with the pack.
7 Remove the 33 dB and non-attenuated optical loopback
cables, the 10-dB LBOs on the OA OUT ports, and the
5-dB LBOs on the TLM IN ports.
8 Remove the loopback from the 1B and 2B Telemetry
circuit packs, and the 15 to 18 dB attenuation used on
the TLM IN ports.
9 Execute CONFIGURATION.Update.System.
10 Repeat Steps 1 to 8 for any other equipped lines until all
lines are tested.
11 When finished testing, enter the SECURITY.
Enter.System command to enable APSD. The APSD
feature must be enabled for safety purposes. See Danger
on previous
page.