Lucent Technologies WaveStar OLS 40G, Installation Manual

Page: 406 / 578

9-16
Issue 1.0 March 2001
365-575-389
Installation Manual
Local Installation Testing
Auto Turnup Local Test (Continued)
Auto Local Turnup
CMS Procedures
(continued)
Auto Turnup Local
SUPR Cautions
!
CAUTION:
To prevent potential damage to the Optical Amplifiers (LEA6, LEA7,LEA7B,
LEA104, or LEA105) or the fiber jumpers themselves, connect the fiber
jumpers to the “IN” and “OUT” ports with these transmission packs
unseated, then latch them into the shelf.
!
DANGER:
Disabling the Automatic Power Shut-Down (APSD) feature results in a FDA/
IEC ClassIIIb/3B laser hazard. APSD is a safety feature. Do not attempt to
defeat or disable APSD. Defeating APSD may result in harm to personnel
exposed to disconnected or cut optical fibers.
!
CAUTION:
To comply with IEC regulations, systems containing an IEC Class 3B laser
hazard must be installed in a controlled environment. Please refer to
applicable IEC standards.
Step Action Reference
6 Remove optical CMS loopback cables.
7 Repeat steps 1 to 6 for any other equipped lines until all
lines are tested.
8 Execute CONFIGURATION.Update.System.
Requirement: The command clears CMS loss of signal
alarms.