Lucent Technologies WaveStar OLS 40G, Installation Manual

Page: 309 / 578

Issue 1.0 March 2001
6-81
365-575-389
Installation Manual WaveStar OLS 40G Fiber and Circuit Pack Installation
One OA/Two OA Dual Facing Shelf
Installation
Description
This configuration is supported by Releases 2.1 and subsequent releases only.
This section covers the installation of a stand-alone Dual Facing Shelf. It is
possible for a second shelf to be installed in the same bay, yet configured
differently. If this is the case, refer to the appropriate subsection for the fibering of
the other shelf.
This section also covers the fiber and label installation for the One OA/Two OA
Dual Facing Shelf Configuration. It has been broken into five procedures:
■
Intrashelf Fiber Jumper Installation
■
Low-Speed Fiber Jumper Installation to SONET/SDH equipment
■
Outside Plant Fiber Jumper Installation to LGX
■
Customer Maintenance Signal Fiber Jumper Installation
■
End Terminal Circuit Pack and Unit Installation
!
CAUTION:
No fiber jumpers shall be connected to the circuit packs or units at this time.
Do not connect the fiber jumpers until instructed to do so.
Circuit Pack Equip
Procedure For
2-Line Shelf
(Continued on next page)
Step Action
1 Review information in the Fiber Cable Routing: page 6-9 and Circuit Pack
Installation: page 6-10 sections before beginning this procedure.
2 Refer to Figure 6-17 for circuit pack locations.