Lucent Technologies WaveStar OLS 40G, Installation Manual

Page: 221 / 578

Issue 1.0 March 2001
5-65
365-575-389
Installation Manual Wired Cable Installation
OLS/OT Integration Cables
Installation (Continued)
Rack and Stack
Configurations
(continued)
Cable installation for Bays 1-3 continues:
Follow the steps below to install the inter shelf cables for Bays 3-5.
(Continued on next page)
Step Action
30 Route the P8 end of the same cable through the right side of the top OT
Complimentary 2 shelf in Bay 3 and attach P8 to the J8 EQPG OUT
connector.
31 Route the P14 end of the ED7G045-20 G10A (or G10, G10B) cable
through the right side of the OT System Controller Shelf of Bay 1 (middle
shelf) and attach P14 to the J14 RESET OUT 2 connector.
32 Route the P16 end of the same cable through the right side of the top OT
Complimentary 2 shelf in Bay 3 and attach P16 to the J16 RESET IN
connector.
33 Route the P7 end of the ED-7G045-20 G806 cable through the right side
of the top OT Complimentary 2 Shelf of Bay 3 and attach P7 to the J7
CTL OUT connector.
34 Remove the termination from J6 of the OT System Controller shelf in Bay
2.
35 Route the P6 end of the same cable through the left side of the OT
System Controller shelf in Bay 2 and attach P6 to the J6 CTL IN
connector.
36 Tie excess cable into left or right bay frame channels.
37 Verify the ED7G045-20 G2 Termination connector is on OT
Complementary Shelf 2 J7 connector of Bay 2.
Step Action
1 Remove the ED-7G028-20 Group 29 cable from the Bay 5 OLS shelf J27
and OT System Controller shelf J8 and J16 connectors.