Lucent Technologies WaveStar OLS 40G, Installation Manual

Page: 205 / 578

Issue 1.0 March 2001
5-49
365-575-389
Installation Manual Wired Cable Installation
OLS/OT Integration Cables
Installation (Continued)
Rack and Stack
Configurations
(continued) Figure 5-9. Bay and Cable Positions for Two Bay Rack and Stack
Configuration
Follow the steps below to install the inter shelf cables.
(Continued on next page)
OLS Shelf Interconnect Panel
BUS OUT (J14)
BUS IN (J15)
CTL OUT B (J27)
OT Complementary
Shelf 1 Interconnect Panel
OT System Controller
Shelf Interconnect Panel
CTL IN (J6)
IAO LAN (J5)
EQPG OUT (J8)
RESET IN (J16)
CTL OUT (J7)
EQPG IN 1 (J9)
RESET OUT 1 (J13)
RESET IN (J16)
EQPG OUT (J8)
CTL IN (J6)
CTL OUT (J7)
OT Complementary
Shelf 1 Interconnect Panel
CTL IN (J6)
IAO LAN (J5)
EQPG OUT (J8)
RESET IN (J16)
CTL OUT (J7)
EQPG IN 1 (J9)
RESET OUT 1 (J13)
CTL IN (J6)
EQPG OUT (J8)
TERMNTN (J7)
OT System Controller
Shelf Interconnect Panel
(P8-2 / P16-2)
(P8-1 / P16-1)
RESET IN (J16)
BAY 2
BAY 1
Step Action
1 Remove the ED-7G028-20 Group 29 cable from the Bay 1, OLS J27 and
OT System Controller Shelf J8 and J16.
2 Route the P27 end of the E-7G028-22 Group 812 cable through the right
side of the OLS shelf of Bay 1 and attach to the J27 CTL OUT (B)
connector on the OLS interconnection panel from which the G29 cable
was removed in Step 1.
3 Route the P8-1/P16-1 ends of the same cable through the right side of
the OT System Controller Shelf (middle shelf of Bay 1) to the
interconnection panel.