Lucent Technologies WaveStar OLS 40G, Installation Manual

Page: 291 / 578

Issue 1.0 March 2001
6-63
365-575-389
Installation Manual WaveStar OLS 40G Fiber and Circuit Pack Installation
Two OA/Two OA Dual Facing Shelf
Installation
Description
This configuration is available with Release 2.1 and subsequent releases only.
Covered in this subsection is the fiber, circuit pack and label installation for a
stand-alone Two OA Dual Facing Shelf. It is possible that this shelf will be coupled
with another shelf in the same bay frame. If that is the case, refer to the
appropriate subsection for the installation of the other shelf.
This subsection covers the installation of the Two OA Dual Facing Shelf
Configuration. It has been broken into five procedures:
■
Intrashelf Fiber Jumper Installation
■
Low-Speed Fiber Jumper Installation to SONET/SDH equipment
■
Outside Plant Fiber Jumper Installation to LGX
■
Customer Maintenance Signal Fiber Jumper Installation
■
End Terminal Circuit Pack and Unit Installation
!
CAUTION:
No fiber jumpers shall be connected to the circuit packs or units at this time.
Do not connect the fiber jumpers until instructed to do so.
Circuit Pack Equip
Procedure for
2-Line Shelf
(Continued on next page)
Step Action
1 Review information in the Fiber Cable Routing: page 6-9 section and the
Circuit Pack Installation: page 6-10 section before beginning this
procedure.
2 Refer to Figure 6-13 for circuit pack locations.