Lucent Technologies WaveStar OLS 40G, Installation Manual

Page: 379 / 578

Issue 1.0 March 2001
8-13
365-575-389
Installation Manual Network Element Startup and Provisioning
Initial Provisioning
Before Beginning
Provisioning The following procedure MUST be done immediately after the software installation
has taken place to avoid travel to all connected sites repeatedly:
NOTE:
Failure to Initialize the system using the following procedures could cause
problems trying to provision the parameters listed in the following section.
Step Action Reference
1 Execute CONFIGURATION.Initialize.System, AID=All,
PH=3 (Reset).
Requirement: The command completes. The full reset
time is about 10 minutes. The reset will cause the CMC
to be disconnected from the network element.
NOTE:
Under certain circumstances, a
CONFIGURATION.Initialize.System, AID=All,
PH=3 will cause an erroneous OA-1A alarm. This
alarm can be cleared with a
CONFIGURATION.Update command.
2 Log back into the network element.