Lucent Technologies WaveStar OLS 40G, Installation Manual

Page: 491 / 578

Issue 1.0 March 2001
12-19
365-575-389
Installation Manual Troubleshooting
Troubleshooting Table
Installation
Troubleshooting
(continued) Table 12-1. Installation Troubleshooting (continued)
(Continued on next page)
Trouble or Error
Message Probable Cause Suggested Solution
Flash EEPROM write
error, during software
installation. Power saver feature of
PC has powered down
serial port. Check PC hardware setup and
disable power saver feature.
SYSMEM failure. Rule out other causes: Replace
SYSMEM.
FAULT LED on after
Reset, Alarm report
says Unrecognized
Pack Type. Slot had circuit pack in it
before and circuit pack
has been changed to
new type. Use Update command from
CMC if new type circuit is what
is wanted. Otherwise, restore
original type circuit pack.
Failed circuit pack. Replace circuit pack.
An incorrect disk was
inserted, during
software installation. Disks are not stored in
order. Check disk labeling, insert disk
requested.
Disks are labeled
incorrectly. Workaround Only: obtain disks
from another site of SAME
GENERIC and use those. To
correct: Contact Customer
service for replacement disks.
FAULT LED flashing On transmission circuit
pack, input signal not
present or not proper
format. Check presence and format of
input signal. If input is not
supposed to be present, use
Update command to clear
trouble.
On SYSMEM. Software mismatch between
SYSCTL and SYSMEM. If
version in SYSMEM is to be
used, use Reset command. If
version in SYSCTL is to be
used, use Install program to
load that version into
SYSMEM.