Lucent Technologies WaveStar OLS 40G, Installation Manual

Page: 282 / 578

6-54
Issue 1.0 March 2001
365-575-389
Installation Manual
WaveStar OLS 40G Fiber and Circuit Pack Installation
One OA 1A-TX End Terminal
Installation (Continued)
Seat OMUs and
ODUs Into Shelf
Refer to Figure 6-9 to seat the OMU and ODU units in the shelf as follows:
!
CAUTION:
Do not seat any other circuit packs in the shelf at this time.
Final Verification
Perform the following steps to ensure that fibers are properly installed:
Step Action
1 Remove the screws from the shelf positions and discard if OMUs and
ODUs are equipped with captive screws.
2 Seat the OMUs and ODUs into the shelf slots.
3 If the OMUs and ODUs are not in their final position, do not tighten the
captive screws.
Step Action
1 Verify that fibers are properly secured and dressed.
2 Verify that optical fiber is protected properly.
3 Verify that all fibers are properly labeled.
4 Verify circuit packs other than the OMU and ODU are installed but not
seated into their backplane connectors.