Remote Control - Commands
NRP2
308
User Manual 1173.9140.02 ─ 07
6.13.10 Operation Status Register
The CONDition register contains information on the operations currently being per-
formed by the device, while the EVENt register contains information on the operations
performed by the device since the last readout of the register.
These two registers can be read by the queries
STATus:OPERation:CONDition?
or
STATus:OPERation[:EVENt]?
.
Table 6-22: Meaning of bits used in the Operation Status Register
Bit No.
Meaning
0
Operation Calibrating Status Register summary bit
This bit is set if one of the sensors is being calibrated.
1 to 3
Not used
4
Operation Measuring Status Register summary bit
This bit is set if one of the sensors is performing a measurement.
5
Operation Trigger Status Register summary bit
This bit is set if a sensor is in the WAIT_FOR_TRG state, i.e. waiting for a trigger event.
6
Not used
7 to 9
Not used
10
O
peration Sense Status Register summary bit
This bit is set if a sensor is initialized.
11
Operation Lower Limit Fail Status Register
This bit is set if a displayed value has dropped below a lower limit value.
12
Operation Upper Limit Fail Status Register
This bit is set if a displayed value has exceeded an upper limit value.
13 to 14
Not used
15
Bit 15 will never be used.
6.13.11 Operation Calibrating Status Register
The CONDition register contains information as to whether a sensor is currently being
calibrated and, depending on the configuration of the transition register, the EVENt
register indicates whether a calibration was started or completed since the last readout
of this register. The Operation Calibration Status Register can be read by the following
commands:
STATus:OPERation:CALibrating[:SUMMary]:CONDition?
STATus:OPERation:CALibrating[:SUMMary][:EVENt]?
.
STATus
北京海洋兴业科技股份有限公司（证券代码：839145）
电话：010-62176775
网址：www.hyxyyq.com
