Rohde & Schwarz NRP2, User Manual

Page: 259 / 419

Remote Control - Commands
NRP2
256 User Manual 1173.9140.02 ─ 07
OUTPut:RECorder<[1]..2>:LIMit:LOWer <lower_limit>
Power
Voltage
3.3 V
0.0 V
3.0 V
OUTP:REC:LIM:LOW OUTP:REC:LIM:UPP
Fig. 6-8: Characteristic of analog outputs
Specifies the lower power limit of the characteristic for one of the two analog outputs .
The unit corresponds to the output unit of the measured value.
Value range: See table 6-10 Value ranges, depending on the unit .
Units: table 6-11 Output unit of measured value of calculate block .
Note: The characteristic is linear in the selected unit of the measured value.
Parameters:
<lower_limit> float_value
*RST:
-20 DBM or 0 DB
OUTPut:RECorder<[1]..2>:LIMit:LOWer:POWer <lower_limit>
Specifies the lower power limit of the characteristic for one of the two analog outputs if
the associated calculate block returns a power (unit
DBM
,
W
or
DBUV
) as measured
value (see figure 6-8 Characteristic of analog outputs ).
Units: DBM | W | DBUV
Parameters:
<lower_limit> float_value
Range:
-120 DBM to 90 DBM
*RST: -20 DBM
Default unit: DBM
OUTPut:RECorder<[1]..2>:LIMit:LOWer:RATio <lower_limit>
Specifies the lower power limit of the characteristic for one of the two analog outputs if
the associated calculate block returns a power ratio (unit
DB
,
DPCT
or
O
) as the mea-
sured value (see figure 6-8 Characteristic of analog outputs ).
Unit: DB | DPCT | O
OUTPut
北京海洋兴业科技股份有限公司（证券代码：839145） 电话：010-62176775 网址：www.hyxyyq.com