Rohde & Schwarz NRP2, User Manual

Page: 260 / 419

Remote Control - Commands
NRP2
257 User Manual 1173.9140.02 ─ 07
Parameters:
<lower_limit> float_value
Range:
-200 DB .. 200 DB
*RST: 0 DB
Default unit: DB
OUTPut:RECorder<[1]..2>:LIMit:UPPer <upper_limit>
Specifies the upper power limit of the characteristic for one of the two analog outputs
(see
figure 6-8 Characteristic of analog outputs ). The unit corresponds to the output
unit of the measured value.
Value range: See table 6-10 Value ranges, depending on the unit .
Unit: table 6-11 Output unit of measured value of calculate block .
Parameters:
<upper_limit> float_value
*RST:
20 DBM or 10 DB
OUTPut:RECorder<[1]..2>:LIMit:UPPer:POWer <upper_limit>
Specifies the upper power limit of the characteristic for one of the two analog outputs if
the associated calculate block returns a power (unit
DBM
,
W
or
DBUV
) as the measured
value (see figure 6-8 Characteristic of analog outputs ).
Unit: DBM | W | DBUV
Parameters:
<upper_limit> float_value
Range:
-120 DBM to 90 DBM
*RST: 20 DBM
Default unit: DBM
OUTPut:RECorder<[1]..2>:LIMit:UPPer:RATio <upper_limit>
Specifies the upper power limit of the characteristic for one of the two analog outputs if
the associated calculate block returns a power ratio (unit
DB
, DPCT or
O
) as the mea-
sured value (see figure 6-8 Characteristic of analog outputs ).
Unit: DB | DPCT | O
Parameters:
<upper_limit> float_value
Range:
-200 DB .. 200 DB
*RST: 10 DB
Default unit: DB
OUTPut
北京海洋兴业科技股份有限公司（证券代码：839145） 电话：010-62176775 网址：www.hyxyyq.com