Rohde & Schwarz CMU-K20, Operating Manual

Page: 98 / 646

Non Signalling: Power Measurements CMU-K20/K21/K22/K23/K24
1115.6088.12 4.20 E-11
f) P/Frame, P/Slot Graph, P/Slot Table
The P/Frame, P/Slot Graph, and P/Slot Table test settings differ from the P/t Normal GMSK settings
(see p. 4.11 ff.) in several respects:
•
The measurement statistics is simplified; only the repetition mode can be set.
•
Everything related to the measurement curve (Display Mode, Markers, Display settings) is omitted.
•
In the P/Slot Table and P/Frame applications, the number of slots to be measured (Slot Count,
Frame Count) can be set.
The remaining settings are identical with those of the P/t Normal GMSK application; see page 4.11 ff.
Note: No Free Run trigger must be used in the P/t Multislot, P/Frame, P/Slot Graph, and P/Slot
Table applications.
Measurement Results
The measurement results depend on the application selected.
a) P/t Normal GMSK
The values shown in the measurement menu Power , application P/t Normal GMSK, can be divided into
three groups:
•
Settings
•
Scalar measurement results (single values)
•
Arrays (the measurement curve plotted as a function of time)
These values are indicated in two parameter lines, the test diagram and an info box:
Parameter line 1, 2
Test diagram
Info box
Fig. 4-4 Display of results (Power – P/t Norm. GMSK)
Settings/
scalar measure-
ment results Settings and scalar measurement results are indicated in the two parameter lines
above the test diagram and in the info box, a popup window in the middle of the
graphical screen
Power .
1
st
parameter line The first parameter line contains the following settings:
Max. Level Maximum expected input level as set in the Analyzer tab of
深圳德标仪器
135-1095-0799