Rohde & Schwarz CMU-K20, Operating Manual

Page: 409 / 646

CMU-K20/21/22/23/24 Common: SPECtrum:MODulation
1115.6088.12 6.105 E-12
CONFigure:SPECtrum:MODulation[:GMSK]:CONTrol:REPetition Test cycles
CONFigure:SPECtrum:MODulation:EPSK:CONTrol:REPetition
< Repetition > ,<StopCondition> , <Stepmode>
<Repetition> Description of parameters Def. value Def. unit
CONTinuous |
SINGleshot |
1 to 10000 Continuous measurement (until
STOP
or
ABORT)
Single shot measurement (until
Status = RDY
)
Multiple measurement
(
counting , until
Status = STEP | RDY)
SING –
<StopCondition> Description of parameters Def. value Def. unit
SONerror |
NONE Stop measurement in case of error (stop on error)
Continue measurement even in case of error
NONE –
<Stepmode> Description of parameters Def. value Def. unit FW vers.
STEP |
NONE Interrupt measurement after each statistics cycle
Continue measurement according to its rep. mode NONE – V1.20
Description of command
This command defines the number of test cycles, the stepping mode and, if required, a stop condition for the
measurement.
Note: In the case of READ commands (
READ:
...), the <Repetition> parameter has no effect; the measure-
ment is always stopped after a single shot.
DISPlay:SPECtrum:MODulation[:GMSK]:CONTrol:GRID <Enable>
DISPlay:SPECtrum:MODulation:EPSK:CONTrol:GRID <Enable> Grid
<Enable> Description of parameters Def. value Def. unit FW vers.
ON |
OFF Switch on grid lines
Switch off grid lines ON – V1.20
Description of command
This command switches the grid lines in the test diagrams on or off.
CONFigure:SPECtrum:MODulation[:GMSK]:CONTrol:MPOint<nr>:ENABle <Enable>
CONFigure:SPECtrum:MODulation:EPSK:CONTrol:MPOint<nr>:ENABle <Enable>
Enable/Disable Measurement Points
<Enable> Description of parameters Def. value Def. unit FW vers.
ON |
OFF Switch on measurement point <nr>
Switch off measurement point <nr> ON – V1.20
Description of command
This command switches the measurement at the individual frequency points no. 1 to 11 (numbered by the nu-
meric suffix <nr>) on or off. Each number denotes a pair of frequency points symmetric to the carrier, <nr>=1
corresponding to
±
0.1 MHz, <nr>=11 to
±
1.8 MHz.
深圳德标仪器
135-1095-0799