Rohde & Schwarz CMU-K20, Operating Manual

Page: 243 / 646

CMU-K20/K21/K22/K23/K24
Signalling: Connection Control
1115.6088.12 4.165 E-12
Timeslot
The
Timeslot
softkey determines the traffic channel timeslot number for the single
slot circuit switched connection.
Remote control
PROCedure:SIGNalling[:CSWitched][:TCH][:SSLot]:TIMeslot
CONFigure:BSSignal[:CSWitched][:TCH][:SSLot]:TIMeslot
Softkey-oriented Version: Multislot Mode
The
Slot Mode
of the mobile can be set by means of the
Slot Mode
softkey before a call is established.
While
Multislot
mode is selected, frequency
Hopping
is set to
Off
and the softkey-oriented version of
the
BS Signal
tab determines
•
A
Frequency Offset
by which the RF frequency of the BS traffic and control channel (BCCH) signal
is modified
•
The transmission
Mode
,
BCCH Level
and GSM channel number
(RF Channel)
of the CMU's
Broadcast Control Channel (BCCH)
•
The definition of the BS signal levels in all timeslots
(Slot Config.)
and the way they are defined
(Level Mode)
•
The GSM channel number
(RF Channel)
of the CMU's traffic channel (TCH)
•
The
Main Timeslot
used for signalling and its GSM channel number
(Main Timeslot)
Fig. 4-74 Connection Control – BS Signal (panel, multislot)
The left half of the BS Signal tab contains the BCCH settings described in section
Softkey-oriented
Version: Single Slot Mode
on p. 4.162 ff. The right half of the BS Signal tab contains the following TCH
settings that are not described in section
Softkey-oriented Version: Single Slot Mode
on p. 4.162 ff.:
深圳德标仪器
135-1095-0799