Rohde & Schwarz CMU-K20, Operating Manual

Page: 377 / 646

CMU-K20/21/22/23/24 Common: MODulation:XPERror
1115.6088.12 6.73 E-12
CONFigure:MODulation:XPERror[:GMSK]:TIME:DECode <Mode> Decode
<Mode> Description of parameters Def. value Def. unit FW vers.
STANdard |
GTBits The standard bit range is decoded
The guard and tail bits are also decoded GTBits – V2.15
Description of command
This command selects the type of decoding applied for the determination of phase and frequency errors.
CONFigure:MODulation:XPERror[:GMSK]:FILTer <Filter> Filter
<Mode> Description of parameters Def. value Def. unit FW vers.
G500 |
B600 500 kHz Gaussian filter
600 kHz bandpass filter G500 – V3.05
Description of command
This command selects the measurement filter for the
XPERror[:GMSK]
modulation measurement.
Subsystem MODulation:XPERror[:GMSK]:CONTrol
The subsystem MODulation:XPERror[:GMSK]:CONTrol configures the modulation measurement. It
corresponds to the Control tab in the popup menu Modulation Config .
CONFigure:MODulation:XPERror[:GMSK]:CONTrol < Mode>, <Statistics > Scope of Measurement
<Mode> Description of parameters Def. value Def. unit
SCALar |
ARRay Only scalar measured values (incl. tolerance matching)
Scalar measured values and arrays ARRay –
<Statistics> Description of parameters Def. value Def. unit FW vers.
1 to 1000 |
NONE No. of bursts within a statistics cycle
Statistics off 100 – V2.15
Description of command
This command selects the type of measured values and determines the number of bursts forming one statistics
cycle.
深圳德标仪器
135-1095-0799