Rohde & Schwarz CMU-K20, Operating Manual

Page: 447 / 646

CMU-K20/21/22/23/24 Signalling: POWer:PCL
1115.6088.12 6.143 E-12
Subsystem POWer:PCL:CONTrol
CONFigure:POWer:PCL:CONTrol:REPetition < Repetition > ,<StopCondition>,<Stepmode>
Test Cycles
<Repetition> Description of parameters Def. value Def. unit
CONTinuous |
SINGleshot |
1 to 10000 Continuous measurement
(
continuous , until
STOP
or
ABORT)
Single measurement (single shot
, until
Status = RDY)
Multiple measurement
(
counting , until
Status = STEP | RDY)
SING –
<StopCond> Description of parameters Def. value Def. unit
SONerror |
NONE Stop measurement in case of error (stop on error)
Continue measurement even in case of error
NONE –
<Stepmode> Description of parameters Def. value Def. unit FW vers.
STEP |
NONE Interrupt measurement after each statistics cycle
Continue measurement according to its rep. mode NONE – VV2.00
Description of command
This command determines the number of statistics cycles and the stepping mode for the measurement.
Note: In the case of READ commands (
READ:
...), the <Repetition> parameter has no effect; the
measurement is always stopped after a single shot.
Subsystem POWer:PCL:CHANnel
The subsystem POWer:PCL:CHANnel defines three or seven channels for the P/PCL measurement.
The subsystem corresponds to the Channel Count hotkey and the MS Signal softkey in the
measurement menu P/PCL.
CONFigure:POWer:PCL:CCOunt <Channels> Channel Count
<Channels> Description of parameters Def. value Def. unit FW vers.
C3 | C7
3 or 7 different channels measured C3 – V2.15
Description of command
This command defines whether three or seven different channels are measured in the P/PCL measurement.
CONFigure:POWer:PCL:CHANnel <Channel1>, ..., <Channeln> Channel
Channel<nr> Value range Def. value: Cannel 1,2,3 Def. unit FW vers.
GSM400
GSM850
GSM900
GSM1800
GSM1900 259 to 293, 306 to 340
128 to 251
0 to 124; 955 to 1023
512 to 885
512 to 810 259,276,293
128,190,251
1,62,124
512,698,885
512,661,810 – VV2.00
4
4
In firmware versions <2.15, only three channels could be measured.
深圳德标仪器
135-1095-0799