Rohde & Schwarz CMU-K20, Operating Manual

Page: 339 / 646

CMU-K20/21/22/23/24 Common: WPOWer
1115.6088.12 6.35 E-12
STATus:OPERation:SYMBolic:ENABle <Event>{,<Event>} Symbolic status evaluation
Parameter list Parameter description
Def. Value
1
Default Unit FW vers.
<Event>{,<Event>} |
NONE List of symbols for events to be reported
No event reported NONE – V3.05
Command description
This command enables event reporting for one or several events in the current GSMxxx-MS Non Signalling
function group, i.e. it sets the corresponding bits in the
STATus:OPERation:CMU:SUM<nr>:CMU<nr_event>:ENABle
register
(<nr> = 1 | 2, <nr_event>
denotes the current function group) and in all sum registers up to the status byte. The events and the
corresponding symbols for the function group are listed in Chapter 5 (see section
Status Registers). The symbols
may be entered in arbitrary order.
STATus:OPERation:SYMBolic[:EVENt]? Symbolic status evaluation
Response Parameter description
Def. Value
2 Default Unit FW vers.
NONE |
<Event>{,<Event>} No event in the RF function group
List of reported events
NONE – V3.05
Command description
This command is always a query. It lists the events reported in the current GSMxxx-MS Non Signalling function
group and deletes these events in the
STATus:OPERation:CMU:SUM<nr>:CMU<nr_event>:EVENt
register
as well as in all sum registers.
WPOWer
The subsystem WPOWer measures the power of the signal transmitted by the mobile phone using a
wideband filter. It corresponds to the softkey Wideband Power in the Connect. Control menu.
INITiate:WPOWer Start new measure ment
⇒
RUN
ABORt:WPOWer Abort measurement and switch off
⇒
OFF
STOP:WPOWer Stop measurement
⇒
STOP
CONTinue:WPOWer Next measurement step (only counting mode )
⇒
RUN
Description of command FW vers.
These commands have no query form. They start or stop the measurement, setting it to the status
given in the top right column. 1.15
3
1
The default values quoted in this command are achieved after a STATus:PRESet command. *RST does not overwrite the entries in the status registers; see section Reset
Values of the Status Reporting Systems in chapter 5.
2
The default values quoted in this command are achieved after a *CLS command. *RST does not overwrite the entries in the status registers; see section Reset Values of
the Status Reporting Systems in chapter 5.
3
For firmware versions <V2.15, the keyword WPOWer is replaced by SPOWer in all commands.
深圳德标仪器
135-1095-0799