Rohde & Schwarz CMU-K20, Operating Manual

Page: 499 / 646

CMU-K20/21/22/23/24 Connection Control (Signalling only)
1115.6088.12 6.195 E-12
CONFigure:NETWork:SYSTem:CACCess <Mode>
Cell Access
Mode>
Description of parameters Def. value Def. unit FW vers.
BARRed |
NBARred
Radio cell disabled for all mobiles
Radio cell accessible NBARred – V1.15
Description of command Sig. State
This command enables or disables the radio cell for mobiles. SOFF,
SON
Q: all
CONFigure:NETWork:SYSTem:BINDicator <Band>
Band Indicator
<Blocks>
Description of parameters Def. value Def. unit FW vers.
G18 | G19
GSM band that the mobile can use see below – V3.10
Description of command Sig. State
This command sets the band indicator of the MS under test. The default value is G18 if the current
function group is GSM400/900 or GSM1800 and G19 if the current function group is GSM850 or
GSM1900.
≠
CEST,
Q: all
CONFigure:NETWork:SYSTem:BSAGblksres <Blocks>
Number of Reserved Blocks
<Blocks>
Description of parameters Def. value Def. unit FW vers.
0 to 7
Number of reserved blocks in the BCCH for access
channel 0 – V1.15
Description of command Sig. State
This command determines the number of data blocks to be reserved for the granted access
(access
grant channel = AGC)
within the BCCH
(basic services access grant blocks reserved)
.
≠
CEST,
Q: all
CONFigure:NETWork:SYSTem:BSPamfrms <Frames>
Paging Request Interval
<Frames>
Description of parameters Def. value Def. unit FW vers.
2 to 9
Interval between two paging requests 2 V1.15
Description of command Sig. State
This command defines the interval between two paging requests in a multiframe in frames
(basic
services paging blocks available per multiframe)
.
≠
CEST,
Q: all
CONFigure:NETWork:SYSTem:BSPReorganis <Mode>
Paging Reorganisation
<Mode>
Description of parameters Def. value Def. unit FW vers.
ON | OFF
Paging reorganization on/off OFF – V2.00
Description of command Sig. State
This command switches the paging reorganization parameter on and off. In the
OFF
state, the mobile
is prevented from switching to the idle mode.
≠
CEST,
Q: all
CONFigure:NETWork:SYSTem:PLUPdate <Value>
TS1232, Periodic Location Update
<Value>
Description of parameters Def. value Def. unit FW vers.
OFF |
0 to 255
No periodic location update performed
Value of T1232 timer OFF deci-
hours
V3.10
Description of command Sig. State
This command sets the value of the timer T3212 of the periodic location updating procedure. The unit
decihours corresponds to 6 minutes or 360 seconds.
≠
CEST,
Q: all
深圳德标仪器
135-1095-0799