Rohde & Schwarz CMU-K20, Operating Manual

Page: 90 / 646

Non Signalling: Power Measurements CMU-K20/K21/K22/K23/K24
1115.6088.12 4.12 E-11
Repetition
The hotkey Repetition determines the repetition mode of the measurement (Single
Shot or Continuous measurement).
Remote control
CONFigure:POWer[:NORMal][:GMSK]:CONTrol:REPetition
<Repetition> ,<StopCond>,<Stepmode>
Stop
Condition
The Stop Condition hotkey sets a stop condition for the measurement (None or On
Limit Failure) .
Remote control
CONFigure:POWer[:NORMal][:GMSK]:CONTrol:REPetition
<Repetition>,
<StopCond> ,<Stepmode>
Display
Mode
The hotkey Display Mode determines the display mode of the measurement curve.
Remote control
no display mode set, the four measurement curves are accessible via
FETCh:ARRAy:POWer[:NORMal][:GMSK][:CURRent]?
FETCh:ARRAy:POWer[:NORMal][:GMSK]:MINimum?
FETCh:ARRAy:POWer[:NORMal][:GMSK]:MAXimum?
FETCh:ARRAy:POWer[:NORMal][:GMSK]:AVERage?
etc.
Statistic
Count
The Statistic Count hotkey defines the number of bursts per statistic cycle.
Remote control
CONFigure:POWer[:NORMal][:GMSK]:CONTrol
<Mode>,1 ... 1000 | NONE
Trig. Slot
Offset
The Trig. Slot Offset hotkey defines a delay time (integer number of GSM
timeslots) between the trigger time and the measured timeslot (see Fig. 4-3 on p.
4.18 . In the default setting (Trig. Slot Offset = 0) the measured timeslot is
determined by the trigger time. By varying the Trig. Slot Offset, an unknown GSM
signal can be analyzed timeslot by timeslot at constant trigger settings.
Remote control
CONFigure:RFANalyzer:MCONTrol:TSOFfset 0 to 7
Analyzer
Level
The Analyzer Level softkey controls the level in the RF input signal path and
provides the trigger settings for the measurements.
The input level and trigger settings are also provided in the Analyzer tab of the
Connection Control menu. For a detailed description see section Table-Oriented
Version on p. 4.73 ff.
RF Max.
Level
The RF Max. Level hotkey sets the maximum expected input level in dBm.
Remote control
[SENSE:]LEVel:MAXimum <Level>
RF
Mode
The RF Mode hotkey determines how the input level is defined.
Manual Manual input via RF Max. Level hotkey
Auto Automatic setting according to the average burst power of the
applied signal.
深圳德标仪器
135-1095-0799