Rohde & Schwarz CMU-K20, Operating Manual

Page: 369 / 646

CMU-K20/21/22/23/24 Common: MODulation[:PERRor]
1115.6088.12 6.65 E-12
FETCh:MODulation[:PERRor][:GMSK]:STATus? Measurement Status
Ret. values Description of parameters Def. value Def. unit FW vers.
OFF |
RUN |
STOP |
ERR |
STEP |
RDY,
1 to 10000 |
NONE,
1 to 1000 |
NONE Measurement in the OFF state (
*RST
or
ABORt
)
Running (after
INITiate, CONTinue
or
READ
)
Stopped (
STOP
)
OFF (could not be started)
Stepping mode (<stepmode>=STEP)
Stopped according to repetition mode and stop condition
Counter for current statistics cycle
No counting mode set
Counter for current evaluation period within a cycle
Statistic count set to off
OFF
NONE
NONE –
–
– V1.15
Description of command
This command is always a query. It returns the status of the measurement (see chapters 3 and 5 of CMU
manual).
CONFigure:MODulation[:PERror][:GMSK]:FILTer <Filter> Filter
<Mode> Description of parameters Def. value Def. unit FW vers.
G500 |
B600 500 kHz Gaussian filter
600 kHz bandpass filter G500 – V3.05
Description of command
This command selects the measurement filter for the
XPERror[:GMSK]
modulation measurement.
Subsystem MODulation[:PERRor][:GMSK]:CONTrol
The subsystem MODulation[:PERRor][:GMSK]:CONTrol configures the modulation measurement. It
corresponds to the Control tab in the popup menu Modulation Config .
Scope of Measurement
CONFigure:MODulation[:PERRor][:GMSK]:CONTrol < Mode>, <Statistics >
<Mode> Description of parameters Def. value Def. unit
SCALar |
ARRay Only scalar measured values (incl. tolerance matching)
Scalar measured values and arrays ARRay –
<Statistics> Description of parameters Def. value Def. unit FW vers.
1 to 1000 |
NONE No. of bursts within a statistics cycle
Statistics off 100 – V1.15
Description of command
This command selects the type of measured values and determines the number of bursts forming one statistics
cycle.
深圳德标仪器
135-1095-0799