Rohde & Schwarz CMU-K20, Operating Manual

Page: 458 / 646

Signalling: Receiver Quality CMU-K20/21/22/23/24
1115.6088.12 6.154 E-12
Receiver Quality – Single Shot
The subsystem RXQuality:BER contains the commands for receiver quality measurements in the single
shot repetition mode. The subsystem corresponds to the main menu Receiver Quality, application BER ,
and the corresponding sections of the associated popup menu Receiver Quality Configuration.
Control of Measurement – Subsystem RXQuality:BER
The subsystem RXQuality:BER controls the single shot receiver quality measurements.
CONFigure:RXQuality:BER:TSETup <TestSetup> Test Setup
<TestSetup> Description of parameters Def. value Def. unit FW vers.
T1 |
T2 |
...
T10 Single Shot Test Setup 1
...
Single Shot Test Setup 10 T1 – V2.00
Description of command
This command selects one out of 10 test setups, i.e. one data set parametrizing a particular single shot receiver
quality measurement. When a new test setup is selected, the running measurement is aborted (measurement
state
OFF) and all measured values are set to INV (invalid). The new measurement must be re-started with
INITiate:RXQuality:BER
.
INITiate:RXQuality:BER Start new measurement
⇒
RUN
ABORt:RXQuality:BER Abort running measurement and switch off
⇒
OFF
STOP:RXQuality:BER Stop measurement
⇒
STOP
CONTinue:RXQuality:BER Next measurement step (only stepping mode )
⇒
RUN
Description of command FW vers.
These commands have no query form. They start or stop the current single shot measurement,
setting it to the status indicated in the top right column. V2.00
CONFigure:RXQuality:BER:EREPorting < Mode > Event Reporting
<Mode> Description of parameters Def. value Def. unit FW vers.
SRQ |
SOPC |
SRSQ |
OFF Service request
Single operation complete
SRQ and SRSQ
No reporting
OFF – V2.00
Description of command
This command defines the events generated when the measurement is terminated or stopped (event reporting,
see chapter 5).
深圳德标仪器
135-1095-0799