Rohde & Schwarz CMU-K20, Operating Manual

Page: 360 / 646

Common: POWer:MSLot CMU-K20/21/22/23/24
1115.6088.12 6.56 E-12
CONFigure:POWer:MSLot:CONTrol:DEFault <Enable> Default Settings
<Enable> Description of parameters Def. value Def. unit FW vers.
ON |
OFF The parameters are set to their default values
Some or all parameters are not set to default ON
– V3.05
Description of command
If used as a setting command with the parameter ON this command sets all parameters of the subsystem to their
default values (the setting OFF causes an error message).
If used as a query the command returns whether all parameters are set to their default values (ON) or not (OFF) .
Test Configuration
The commands of the following subsystems configure the P/t Multislot measurement. They correspond
to some of the softkey/hotkey combinations in the graphical measurement menu and to some of the
settings in the
Power Configuration popup menu that are related to the P/t Multislot measurement.
CONFigure:POWer:MSLot:MVIew <Mod_-1>,<Mod_0>, <Mod_1>, <Mod_2> Modulation View
<Mod_1>, ... , <Mod_2> Description of parameters Def. value Def. unit FW vers.
GMSK |
EPSK |
ANY |
OFF GMSK modulation required
8PSK modulation required
GMSK or 8PSK modulation
Inactive timeslot (power off) required ANY – V3.05
Description of command
This command defines the modulation schemes and power/time templates for the Meas. Timeslot –1, Meas.
Timeslot and the two following timeslots. Values for timeslots that are currently switched off (see command
CONFigure:POWer:MSLot:SCOunt ) are not taken into consideration.
CONFigure:POWer:MSLot:SCOunt <Slots> Slot Count
<Slots> Description of parameters Def. value Def. unit FW vers.
1 |
2 |
3 |
4 Meas. timeslot (MTS)
MTS – 1, MTS
MTS – 1, MTS, MTS + 1
MTS – 1, MTS, MTS + 1, MTS + 2 2 – V3.05
Description of command
This command defines the number of timeslots measured and determines the length of the measurement arrays
(see
READ:ARRay:POWer:MSLot
...
commands). The measured timeslot is defined via
CONFigure:RFANalyzer:MCONtrol:TSOFfset
(Non Signalling) or
CONFigure:MSSignal:MCONtrol:MESLot
(Signalling).
CONFigure:POWer:MSLot:TOFFset <Offset> Timing Offset
<Offset> Description of parameters Def. value Def. unit FW vers.
–4.00 to +4.00 Number of bits (in ¼ symbol steps) 0 symb. V3.05
Description of command
This command defines an offset time by which the burst is shifted relative to the time axis and the tolerance
template. The values entered are rounded to ¼ symbol steps.
深圳德标仪器
135-1095-0799